Add a Data Gateway

In the navigation pane, select O&M Management > Migration Resource > Data Gateway.
On the Data Gateway page, click Add Data Gateway.
In the Add Data Gateway dialog, set the following parameters:
- Name: Set a name for the data gateway.
- Addition Method: Select the method for adding the data gateway. You can create a new virtual machine or use an existing IP address.
  
  If you select New Virtual Machine:
  - Data Center: Select the data center where the virtual machine resides.
  - Location: Select where the virtual machine runs.
  - CPU: Default is 8 cores. Set the number of CPU cores.
  - Memory: Default is 8 GB. Set the memory size.
  - Storage Location: Specify the data storage.
  - Disk 1: Default is 100 GB. Set the system disk size.
  - Network: Specify a distributed port group. Ensure that the selected distributed port group has network connectivity with both the source platform and the destination platform to guarantee data transfer.
  - IPv4 Address: Specify the IP address.
    
    The IP address allocation method depends on the configuration of the selected migration network:
    - When DHCP is enabled on the migration network, the system automatically assigns an IP address.
    - When DHCP is not enabled on the migration network, you must manually specify an IP address.
    - When IP address management is enabled on the migration network, if you manually specify an IP address, ensure that the address is within the selected network segment. If you select Existing IP:
  - IP Address: Enter the IP address.
  - Host Name: After the IP address is connected, the corresponding name is automatically retrieved.
  - Connectivity Check: Click Check to verify network connectivity.
Review the configuration and click OK.